SKU 94121 For technical questions, please call 1-800-444-3353. Page 6
To Attach The Front Wheels:
1. Insert the Front Spindle (52) through the two mounting holes located at the front
of the Motorcycle Lift frame. Then, insert one Washer (43) and tighten one Nut
(42) onto each protruding end of the Front Spindle. (See Figure A.)
2. Insert one Front Wheel (44) onto each protruding end of the Front Spindle (52).
Then, insert one Washer (43) onto each protruding end of the Front Spindle.
(See Figure A.)
3. Secure the Front Wheels (44) to the Front Spindle (52), by inserting one Cotter
Pin (47) through each protruding end of the Front Spindle. Make sure to bend
the Cotter Pins after insertion. (See Figure A.)
FRONT SPINDLE (52)
WASHER (43)
WASHER (43)
NUT (42)
NUT (42)
COTTER PIN (47)
COTTER PIN (47)
CASTER (14)
FRONT WHEEL
(44)
WASHER (43)
WASHER (43)
FRONT WHEEL (44)
BOLT (12)
WASHER (13)
NUT (21)
LOCK WASHER (20)
WASHER (13)
FIGURE A
1. For best service, you should incorporate an oiler, regulator, and inline filter, as
shown in the diagram on the next page. Hoses, couplers, oilers, regulators, and
filters are all available at Harbor Freight Tools. NOTE: If an automatic oiler is not
used, put 3-5 drops of pneumatic Tool Oil (not included) in the Motorcycle Lift’s
Quick Coupler (38A) before each use. (See Figure B, next page.)
To Connect The Motorcycle Lift To An Air Compressor:
ADJUSTING
SCREW
(18)
2. Align the four mounting holes in each Caster (14) assembly with the four
mounting holes located on the right and left side of the Motorcycle Lift frame.
Then secure the two Caster Wheels to the frame of the unit, using four Bolts (12),
eight Washers (13), four Lock Washers (20), and four Nuts (21) for each Caster
Wheel. (See Figure A.)
Screws (18) clockwise. (See Figure A.)
