SKU 94121 For technical questions, please call 1-800-444-3353. Page 11
10. Remove the Locking Bar (22). Then slowly press the Release Foot Pedal (10) to
slowly lower the Platform (35) to the floor. (See Figure E.)
11. With assistance, remove the tie-down straps from the motorcycle and U-Clamps
(8). Loosen the Vise assembly (34). Kick the center stand of the motorcycle up.
Then, slowly back the motorcycle completely off the Motorcycle Lift.
(See Figure E.)
12. Turn off the air compressor. Squeeze the Air Valve (37P) to release any remaining
compressed air in the system. Then, disconnect the compressor’s air hose from
the Motorcycle Lift. (See Figure E.)
13. Remove the Lift Foot Pedal (11) and Release Foot Pedal (10), and store them
with the Motorcycle Lift in a clean, dry, safe location out of reach of children and
other unauthorized people. (See Figure E.)
INSPECTION, MAINTENANCE, AND CLEANING
1. Before each use, inspect the general condition of the Motorcycle Lift. Check for
cracked, worn or damaged parts, loose or missing parts, low or no hydraulic oil,
and any other condition that may affect the tool’s safe operation. If a problem
occurs, have the problem corrected before further use.
Do not use damaged equipment.
2. Bleeding Hydraulic System. If the Motorcycle Lift is not working properly, it may
be because the hydraulic system has air in the system. To remedy this problem
the hydraulic system must be bled. See Bleeding Instructions on page 12
(Trouble Shooting Section).
3. To clean, use a damp cloth and a mild detergent. Do not use solvents or other
flammable agents.
4. When storing, keep the Motorcycle Lift and its accessories in a clean, dry, safe
location out of reach of children and other unauthorized people.
5. CAUTION! All maintenance, service, and repairs not discussed in this
manual should only be performed by a qualified service technician.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF
HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY
