CHAPTER 4. USING THE FEATURES
To page using a Page button:
1.
Check status of lamp associated with desired paging zone button.
• Lamp dark—paging zone idle; go to Step 2.
• Lamp lighted—paging zone in use; wait for lamp to go dark; then go to Step
2.
2. Press the desired paging zone button.
• Lamp associated with button pressed and lamp associated with Page All
button (if provided) light.
• If Page All button is pressed, all lamps associated with a page button light.
3. Speak into handset to make the announcement.
Ž Announcement heard in desired paging zone; go to Step 4.
• Intercept tone—announcement was too long; try again.
4.
Press
[Release].
• Procedure complete.
To page by dialing an access code:
1.
Press [Start].
Ž Dial tone heard.
Ž Atnd lamp at idle call appearance button lights.
2. Dial desired Loudspeaker Paging Access code, and listen for tone.
Ž Confirmation tone—paging zone available; go to Step 3.
Ž Busy tone—paging zone in use; go to Step 4.
3. Speak into handset to make announcement.
• Announcement heard in desired paging zone; go to Step 5.
• Intercept tone—announcement was too long; try again.
4-30
