Filter
Top Products
A
88
2
3
1
2
3
4
5
99
1
Operation Operation
When the set time is counting down, the time indicator
will change indicating the time remaining.
8
1
2
3
B
Music Selection
Time Setting
Relaxing music can be turned on when the Oxygen Bar is in operation.
Turn on the music selection as follows:
Press the Music selection button one time, the first music selection
indicator will light and first music will be on continuously.
Press the Music selection button two times, the second music selection
indicator will light and second music will be on continuously.
Press the Music selection button three times, the third music selection
indicator will light and third music will be on continuously.
Press the Music selection button four times, the fourth music selection
indicator will light and fourth music will be on continuously.
Press the Music selection button five times, all the music selection
indicators will light and music will be on sequentially from the first one to
the fourth one.
Press the Music selection button six times, all the
music indicators will be off and music will stop.
Music volume can be adjusted. Use the volume control button to
adjust the sound volume.
Music can not play alone when the Oxygen Bar operation stops.
C
End of Operation Cycle
When the set time ends, the machine will automatically
activate the blowing cycle for one minute in order to
speed up the discharge of vapors.
After the blowing ends, the heat dispelling
fan will continue to run for 3 minutes to
drive away hot air. The machine will then
turn off automatically. Turn the power
switch off if you are not going to use it
within a short time.
If the unit will not be used for a period of
time, remove the power cord from electrical
outlet.
Exhaust
gas vent
A
Cleaning Condensation
Chamber
During operation, water vapor will
condense and therefore, there is a
condensation chamber in the middle
section of the external connection hose.
If water in the condensation chamber
exceeds 1/3, pour the water out by
gently twisting the condensation
chamber to open it.
Then lightly shake both the upper and
lower end of the condensation chamber
and then re-assemble the condensation
chamber.
If the water accumulation exceeds more than 1/2, it may cause water
backflow and resulting water accumulation on the external connection hose.
Sometimes excessive water will cause abnormal sounds generated by
bubbles and this can be solved by clearing the accumulated water.
Accumulated water
Open Close
9
B
Changing the Air Intake Filters
C
Cleaning the Headset Tube and Headset
1
2
3
4
5
11
1
Maintenance Maintenance
Troubleshooting
Danger
Turn off the unit and remove the Power Cord
from the electrical outlet before maintenance to
avoid electrical shock.
Pull out the two Intake Filter Panels on
the rear of the machine.
Rinse them thoroughly with warm tap
water.
Shake out water, put in a dry place and
allow to air dry.
Replace the Intake Filters.
Clean the Intake Filters once a month. If
the Oxygen Bar is used frequently, the
Intake Filters will have to be cleaned
every two weeks.
Intake Filter
Panel
During the use of Oxygen
concentrator, there will be
water condensation in the
condensation chamber
and headset tube. Proper
cleaning is necessary if not
used for a long period of
time.
2
2
1
3
Separate the Condensation chamber and front part of headset
tube from unit, and rinse these parts with warm water and allow
the parts to air dry.
Re-attach the parts to the unit.
Oxygen Inlet
D
Cleaning the Cabinet
Wipe the cabinet with a soft, moist, clean cloth.
Do not use washing detergent, benzene, thinner or alcohol.
A : Unit does not turn on
1. Check power source and connections.
2. Check that your wall outlet is live.
3. Check that power cord is not damaged.
B: Motor runs, but no oxygen is emitted.
1. Check all hose connections.
2. Check for damaged hoses or hose kinks.
3. Check that filters are clean.
C: Limited oxygen flow
1. Check for damaged hoses or hose kinks.
2. Check voltage of wall outlet.
3. Check that filters are clean.
Oxygen InletAttach the Parts
2
3
Separate the Condensation chamber and front part of headset
tube from unit, and rinse these parts with warm water and allow
the parts to air dry.
Re-attach the parts to the unit.
A
88
2
3
1
2
3
4
5
99
1
Operation Operation
When the set time is counting down, the time indicator
will change indicating the time remaining.
8
1
2
3
B
Music Selection
Time Setting
Relaxing music can be turned on when the Oxygen Bar is in operation.
Turn on the music selection as follows:
Press the Music selection button one time, the first music selection
indicator will light and first music will be on continuously.
Press the Music selection button two times, the second music selection
indicator will light and second music will be on continuously.
Press the Music selection button three times, the third music selection
indicator will light and third music will be on continuously.
Press the Music selection button four times, the fourth music selection
indicator will light and fourth music will be on continuously.
Press the Music selection button five times, all the music selection
indicators will light and music will be on sequentially from the first one to
the fourth one.
Press the Music selection button six times, all the
music indicators will be off and music will stop.
Music volume can be adjusted. Use the volume control button to
adjust the sound volume.
Music can not play alone when the Oxygen Bar operation stops.
C
End of Operation Cycle
When the set time ends, the machine will automatically
activate the blowing cycle for one minute in order to
speed up the discharge of vapors.
After the blowing ends, the heat dispelling
fan will continue to run for 3 minutes to
drive away hot air. The machine will then
turn off automatically. Turn the power
switch off if you are not going to use it
within a short time.
If the unit will not be used for a period of
time, remove the power cord from electrical
outlet.
Exhaust
gas vent
A
Cleaning Condensation
Chamber
In areas of high humidity, during
operation, water vapor will condense
and therefore, there is a condensation
chamber in the middle section of the
external connection hose.
If water in the condensation chamber
exceeds 1/3, pour the water out by
gently twisting the condensation
chamber to open it.
Then lightly shake both the upper and
lower end of the condensation chamber
and then re-assemble the condensation
chamber.
If the water accumulation exceeds more than 1/2, it may cause water
backflow and resulting water accumulation on the external connection hose.
Sometimes excessive water will cause abnormal sounds generated by
bubbles and this can be solved by clearing the accumulated water.
Accumulated water
Open Close