Filter
Top Products
A
88
2
3
1
2
3
4
5
99
1
Operation Operation
When the set time is counting down, the time indicator
will change indicating the time remaining.
8
1
2
3
B
Music Selection
Time Setting
Relaxing music can be turned on when the Oxygen Bar is in operation.
Turn on the music selection as follows:
Press the Music selection button one time, the first music selection
indicator will light and first music will be on continuously.
Press the Music selection button two times, the second music selection
indicator will light and second music will be on continuously.
Press the Music selection button three times, the third music selection
indicator will light and third music will be on continuously.
Press the Music selection button four times, the fourth music selection
indicator will light and fourth music will be on continuously.
Press the Music selection button five times, all the music selection
indicators will light and music will be on sequentially from the first one to
the fourth one.
Press the Music selection button six times, all the
music indicators will be off and music will stop.
Music volume can be adjusted. Use the volume control button to
adjust the sound volume.
Music can not play alone when the Oxygen Bar operation stops.
C
End of Operation Cycle
When the set time ends, the machine will automatically
activate the blowing cycle for one minute in order to
speed up the discharge of vapors.
After the blowing ends, the heat dispelling
fan will continue to run for 3 minutes to
drive away hot air. The machine will then
turn off automatically. Turn the power
switch off if you are not going to use it
within a short time.
If the unit will not be used for a period of
time, remove the power cord from electrical
outlet.
Exhaust
gas vent
A
Cleaning Condensation
Chamber
During operation, water vapor will
condense and therefore, there is a
condensation chamber in the middle
section of the external connection hose.
If water in the condensation chamber
exceeds 1/3, pour the water out by
gently twisting the condensation
chamber to open it.
Then lightly shake both the upper and
lower end of the condensation chamber
and then re-assemble the condensation
chamber.
If the water accumulation exceeds more than 1/2, it may cause water
backflow and resulting water accumulation on the external connection hose.
Sometimes excessive water will cause abnormal sounds generated by
bubbles and this can be solved by clearing the accumulated water.
Accumulated water
Open Close
8
1
1
2
2
3
4
Around Neck PlacementOver Ear Placement
A
[ Headset ]
Diagram - Headset Operation
Headset
Headset Flexible Arm
Oxygen Outlet
Headset Tube
Operation
Getting started
Open the box containing your Tranquil Sounds
Oxygen Bar, check the contents and make sure the
following components are enclosed:
Oxygen concentrator unit
Headset and hose (including optional condensation
chamber
)
Operation manual
If there are missing items, please contact the
dealer where you purchased your Tranquil Sounds
Oxygen Bar.
Read user manual carefully.
Connect the hose provided to the oxygen outlet on the side of the Oxygen Bar.
Operating Procedure
Place unit on a stable, flat surface which is clean
and free of dust. Do not set base on carpet or
other soft surface as this could cause air flow
restriction and damage to unit.
Check to see that the power switch is in the " "
(OFF) position.
Plug power cord into electrical outlet.
3
4
Press the power switch to " " (ON) position. The power switch is located at
the back of the machine in the lower bottom corner. When the power switch is
turned on it is in “stand by” status and there is no indication light.
Position the headset over your ears and adjust the position of the flexible arm.
Press the “On” button on the control panel to start the machine.
The fixed time setting is 10 minutes. The music does not operate unless turned on.
Set the running time by pressing the Start Timer Button as follows :
Positioning headset:
Time Setting
1
1
2
Move the arm in an
up/down direction to adjust
the oxygen inlet.
Oxygen Inlet
Larger Hole
Larger Hole
Small Hole
Small Hole
( Less air flow ) ( More air flow )
Press the Button one time and the unit will run 20 minutes, and the 20
minute indicator window will light.
Press the Button two times and the unit will run 30 minutes and the 30
minute indicator window will light.
Press the Button three times and the unit will run 40 minutes and the 10
minutes and 30 minutes indicator window will light.
Press the Button four times and the unit will run 50 minutes and the 20
minutes and 30 minutes indicator window will light.
Press the Button five times and the unit will run 60 minutes and the 10
minutes, 20 minutes and 30 minutes indicator window will light.
Press the Button one time again and the unit running time will be reset to
10 minutes.
Adjusting Knob for
Oxygen Inlet Postion
Adjust Air Flow
When the set time is counting down, the time indicator
will change indicating the time remaining.
3
*In areas of high humidity,
use the condensation
chamber to collect excess
water condensate from the
unit.
Note: Using the
condensation chamber will
reduce airflow. Use only if
necessary.
*
1
1
2
2
3
4
Around Neck PlacementOver Ear Placement
A
[ Headset ]
Diagram - Headset Operation
Headset
Headset Flexible Arm
Oxygen Inlet
Headset Tube
Condensation Chamber
Operation
Getting started
Open the box containing your Tranquil Sounds
Oxygen Bar, check the contents and make sure the
following components are enclosed:
Oxygen concentrator unit
Headset and hose (including condensation
chamber
)
Operation manual
If there are missing items, please contact the
dealer where you purchased your Tranquil Sounds
Oxygen Bar.
Read user manual carefully.
Connect the hose provided to the oxygen outlet on
the side of the Oxygen Bar.
Operating Procedure
Place unit on a stable, flat surface which is clean
and free of dust. Do not set base on carpet or
other soft surface as this could cause air flow
restriction and damage to unit.
Check to see that the power switch is in the " "
(OFF) position.
Plug power cord into electrical outlet.
3
4
Press the power switch to " " (ON) position. The power switch is located at
the back of the machine in the lower bottom corner. When the power switch is
turned on it is in “stand by” status and there is no indication light.
Position the headset over your ears and adjust the position of the flexible arm.
Press the “On” button on the control panel to start the machine.
The fixed time setting is 10 minutes. The music does not operate unless turned on.
Set the running time by pressing the Start Timer Button as follows :
Positioning headset:
Time Setting
1
1
2
Move the arm in an
up/down direction to adjust
the oxygen inlet.
Oxygen Inlet
Larger Hole
Larger Hole
Small Hole
Small Hole
( Less air flow ) ( More air flow )
Press the Button one time and the unit will run 20 minutes, and the 20
minute indicator window will light.
Press the Button two times and the unit will run 30 minutes and the 30
minute indicator window will light.
Press the Button three times and the unit will run 40 minutes and the 10
minutes and 30 minutes indicator window will light.
Press the Button four times and the unit will run 50 minutes and the 20
minutes and 30 minutes indicator window will light.
Press the Button five times and the unit will run 60 minutes and the 10
minutes, 20 minutes and 30 minutes indicator window will light.
Press the Button one time again and the unit running time will be reset to
10 minutes.
Adjusting Knob for
Oxygen Inlet Postion
Adjust Air Flow
When the set time is counting down, the time indicator
will change indicating the time remaining.
3
1
1
2
2
3
4
Around Neck PlacementOver Ear Placement
A
[ Headset ]
Diagram - Headset Operation
Headset
Headset Flexible Arm
Oxygen Outlet
Headset Tube
Operation
Getting started
Open the box containing your Tranquil Sounds
Oxygen Bar, check the contents and make sure the
following components are enclosed:
Oxygen concentrator unit
Headset and hose (including optional condensation
chamber
)
Operation manual
If there are missing items, please contact the
dealer where you purchased your Tranquil Sounds
Oxygen Bar.
Read user manual carefully.
Connect the hose provided to the oxygen outlet on the side of the Oxygen Bar.
Operating Procedure
Place unit on a stable, flat surface which is clean
and free of dust. Do not set base on carpet or
other soft surface as this could cause air flow
restriction and damage to unit.
Check to see that the power switch is in the " "
(OFF) position.
Plug power cord into electrical outlet.
3
4
Press the power switch to " " (ON) position. The power switch is located at
the back of the machine in the lower bottom corner. When the power switch is
turned on it is in “stand by” status and there is no indication light.
Position the headset over your ears and adjust the position of the flexible arm.
Press the “On” button on the control panel to start the machine.
The fixed time setting is 10 minutes. The music does not operate unless turned on.
Set the running time by pressing the Start Timer Button as follows :
Positioning headset:
Time Setting
1
1
2
Move the arm in an
up/down direction to adjust
the oxygen inlet.
Oxygen Inlet
Larger Hole
Larger Hole
Small Hole
Small Hole
( Less air flow ) ( More air flow )
Press the Button one time and the unit will run 20 minutes, and the 20
minute indicator window will light.
Press the Button two times and the unit will run 30 minutes and the 30
minute indicator window will light.
Press the Button three times and the unit will run 40 minutes and the 10
minutes and 30 minutes indicator window will light.
Press the Button four times and the unit will run 50 minutes and the 20
minutes and 30 minutes indicator window will light.
Press the Button five times and the unit will run 60 minutes and the 10
minutes, 20 minutes and 30 minutes indicator window will light.
Press the Button one time again and the unit running time will be reset to
10 minutes.
Adjusting Knob for
Oxygen Inlet Postion
Adjust Air Flow
When the set time is counting down, the time indicator
will change indicating the time remaining.
3
*In areas of high humidity,
use the condensation
chamber to collect excess
water condensate from the
unit.
Note: Using the
condensation chamber will
reduce airflow. Use only if
necessary.
*