Filter
Top Products
8
3. Attach each Base Extension (45) to the Base
(
52) with two M8 x 58mm Bolts (13), two M8 Flat
Washers (32), and two Base Extension Nuts
(43). Note: The heads of the Bolts should be
on outside of the Base Extensions.
Lower the Base (52) so that it is flat on the floor.
3
52
32
45
13
43
Bolt Head
13
32
45
43
4. Position the Base (52) as close to the front of the
treadmill as possible, as shown.
See the upper inset drawing. Locate the wire
tie in the lower end of the Right Upright (54). Tie
the wire tie securely around the end of the Wire
Harness (39). Then, locate the other end of the
wire tie in the upper end of the Right Upright.
Pull the upper end of the wire tie until the Wire
Harness is extending from the upper end of the
Right Upright. Secure the Wire Harness to the
Right Upright so that it will not fall inside.
See the lower inset drawing. Press the indi-
cated Grommet (49) into the Right Upright (54).
54
54
49
39
52
Wire Tie
39
52
4
39
54