Filter
Top Products
1111
9. Start all six M8 x 15mm Bolts (8) with six M8
S
tar Washers (5) into the Uprights (53, 54).
Then, firmly tighten all six Bolts.
9
5
8
8
5
5
5
8
54
53
10. Attach the Latch Housing (48) and the Latch
Housing Spacer (109) to the Left Upright (53)
with two #10 x 1" Tek Screws (112); start both
Tek Screws before tightening either of them.
Make sure that the large hole in the Latch
Housing is on the indicated side.
Locate the Latch Pin Assembly (24). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are
two collars, place one on each side of the
spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
112
Pin
Spring
Collar
Knob
48
109
53
Large Hole
10
24