Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. In addition to the included allen wrench, assembly
requires a phillips screwdriver , an adjustable wrench ©_ and scissors _- --_.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Handrail Washer (80)--4
Latch Screw/Rack Screw (14)-14 Base Leg Screw (39)-2
Handrail Star
Washer (2)---4
Console Screw (3)=4
1. With the help of a second person, raise the Uprights (38)
to the position shown. Note: During this step and step
2, be careful not to pull on or damage the Wire
Harness (53) in the right Handrail (4).
Insert one of the Base Legs (44) into the right Upright
(38), with the Base Leg Pad (33) in the indicated position.
Using the included Allen Wrench (81), attach the Base
Leg with a Base Leg Screw (39). Attach the other Base
Leg (not shown) to the left Upright in the same way.
Note: A replacement Base Leg Pad (33) may be included.
If a Base Leg Pad becomes worn and needs to be
replaced, use the replacement Base Leg Pad.
2. Hold the Left Handrail (88) against the left Upright (38) as
shown. (Important: If you are shorter than 5' 8", align
the upper two holes in the Handrail with the holes in
the Upright; if you are 5' 8" or taller, align the lower
two holes.) Attach the Left Handrail with two Handrail
Bolts (1), two Handrail Washers (80), and two Handrail
Star Washers (2) as shown. Do not tighten the Handrail
Bolts yet.
Make sure that at least 6" to 8" of the Wire Harness (53)
is extending from the top of the Right Handrail (4). Feed
the excess Wire Harness into the right Upright (38), and
hold the Right Handrail against the right Upright. Make
sure that both Handrails are at the same height.
Attach the Right Handrail with two Handrail Bolts (1), two
Handrail Washers (80), and two Handrail Star Washers
(2). Do not tighten the Handrail Bolts yet. Be careful
not to pinch the Wire Harness. Remove the tie from the
Wire Harness and the Handrail.
81
33
38
80
53
53