Filter
Top Products
9
9. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in
a secure place. The hex key is used to adjust the walking belt (see page 17). To protect the floor or carpet,
place a mat under the treadmill.
8
. Carefully lower the Handrails (6, 7) to the floor. Center the
Frame (55) between the Handrails, and tighten the four
H
andrail Bolts (12). Then, raise the Handrails to the verti-
cal position.
See drawing 8a. Attach the Latch Assembly (41) to the
L
eft Handrail (7) with two 16mm Screws (58).
M
ake sure
that the Latch Assembly is oriented as shown.
See
HOW TO CHANGE THE INCLINE OF THE TREAD-
MILL on page 13. Adjust the incline legs and insert
the incline pins into the incline legs.
41
7
58
8
8a
6, 7
55
12