Filter
Top Products
9
12
3
6
9
10
12
3
6
9
16. Insert the end of the Long Cable (66) through the
indicated bracket on the Top Frame (67), and
down through the indicated hole in the Top
Frame.
Hold a 3 1/2” Pulley (15) inside the bracket on the
Top Frame (67). The Long Cable (66) must be
between the Pulley and the top of the bracket.
Attach the Pulley to the bracket with a 3/8” x 1
3/4” Bolt (12) and 3/8” Jam Nut (6).
17. Insert the Long Cable (66) between the “I” Plates
(78).
Lay the Long Cable (66) over a 3 1/2” Pulley (15)
(see the inset drawing). Attach the Pulley and a
Cable Trap (59) to the Wide Swivel Bracket (71)
with a 3/8” x 1 3/4” Bolt (12) and 3/8” Jam Nut (6).
The Cable Trap must be turned to the “10 o’clock”
position.
18. Wrap the Long Cable (66) down around a 3 1/2”
Pulley (15). Attach the Pulley and a Cable Trap
(59) to the Narrow Swivel Bracket (58) on the left
Arm (46) with a 3/8” x 1 3/4” Bolt (12) and 3/8”
Jam Nut (6). The Cable Trap must be turned to
the “3 o’clock” position.
19. Attach the Adjustment “U” Bracket (75) to the
Front Upright (42) with a 5/16” x 3” Bolt (17),
5/16” Flat Washer (8) and 5/16” Nylon Lock Nut
(3). Note: This Bracket is used to adjust the
tension of the Long Cable. Thread the Nylon
Lock Nut onto the Bolt only two complete
turns.
Wrap the Long Cable (66) around a 4 1/2” Pulley
(77). Attach the Pulley to the Adjustment “U”
Bracket (75) with a 3/8” x 1 3/4” Bolt (12) and 3/8”
Jam Nut (6).
16
18
17
19
12
67
Bracket
6
66
12
71
71
66
78
15
59
6
12
46
58
15
59
77
17
6
75
12
66
3
8
42
66
6
66
15