Filter
Top Products
12
27. Wet the ends of the Lat Bar and insides of the two
remaining Handgrips (48) with soapy water. Slide
the Handgrips onto the ends of the Lat Bar.
27
85
48
48
29. Make sure that all parts are properly tightened. The use of all remaining parts will be explained in ADJUST-
MENT, beginning on page 13 of this owner's manual. Before using the weight system, pull each cable a few
times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move
smoothly, locate and correct the problem before using the weight system. IMPORTANT: If the cables are
not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on
page 18 of this owner’s manual.
28. Remove the decals from the Decal Sheet (not shown), and apply them to the weight system in the locations
shown in the drawing below.
WG7150
28
BENCH PRESS/
BUTTERFLY COMBINATION
LEG EXTENSION
HIGH PULLEY
LOW PULLEY