Filter
Top Products
11
23. Attach the Backrest (41) to the Front Upright (42)
with two 1/4” x 2 1/2” Screws (43) and 1/4” Flat
Washers (10).
24. Press a 1 1/2” Inner Cap (32) into the Seat Frame
(36).
Insert a 1/4” x 2” Carriage Bolt (38) into the center
of each Seat Plate (37). Attach the Seat Plates to
the Seat (13) with four 1/4” x 3/4” Screws (18).
Insert the two 1/4” x 2” Carriage Bolts (38) into
the Seat Frame (36). Make sure that the Seat
(13) is turned so the wide end is towards the
1 1/2” Inner Cap (32). Tighten two 1/4” Nylon
Lock Nuts (7) with 1/4” Flat Washers (10) onto the
Carriage Bolts.
25. Press a 1 1/2” Inner Cap (32) into the Leg Lever
(29).
Lubricate a 5/16” x 2 1/4” Bolt (33). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and a 5/16” Nylon Lock Nut (3). Do not
overtighten the Nylon Lock Nut; the Leg Lever
must be able to pivot freely.
Insert the 5/16” x 2” Eyebolt (35) through the Leg
Lever (29) from the indicated side. Slide a 5/16”
Flat Washer (8) onto the Eyebolt and tighten a
5/16” Nylon Lock Nut (3) onto the Eyebolt.
26. Set the bracket on the Seat Frame (36) on the
indicated pins on the Front Upright (42). Attach
the Seat Frame with a 5/16” x 2 3/4” Carriage
Bolt (14) and the Seat Knob (40).
Press 3/4” Round Inner Caps (34) into the ends
of the 13 1/2” Pad Tube (28) and the 13” Pad
Tube (31).
Insert the 13 1/2” Pad Tube (28) into the Seat
Frame (36). Slide a 6” Pad (30) onto each end of
the Pad Tube.
Insert the 13” Pad Tube (31) into the Leg Lever
(29). Slide a 5 3/4” Pad (50) onto each end of the
Pad Tube.
23
43
42
13
Wide
End
32
7
29
3
33—Lubricate
35
8
3
32
31
28
29
50
34
30
30
36
40
14
42
Pin
50
34
36
18
10
37
36
38
37
41
10
24
25
26