Filter
Top Products
9
FEATURES OF THE CONSOLE
The easy-to-use console features six modes that pro-
vide instant exercise feedback during your workouts.
The modes are described below.
Speed—This mode displays your pedalling
speed, in kilometres per hour or miles per hour.
Time—This mode displays the elapsed time.
Note: If you stop pedalling for a few seconds,
the time mode will pause.
Distance—This mode displays the distance you
have pedalled, in kilometres or miles.
Calorie—This mode displays the approximate
number of calories you have burned.
Heart Rate—This mode displays your heart rate
when you use the pulse sensor.
Scan—This mode displays the speed, time, dis-
tance, calorie, and heart rate modes, for a few
seconds each, in a repeating cycle. Note: The
heart rate mode will be displayed only when the
pulse sensor is being used.
HOW TO OPERATE THE CONSOLE
Make sure there are batteries in the console (see
BATTERY REPLACEMENT on page 11). If there is a
thin sheet of clear plastic on the console, remove it.
Follow the steps below to operate the console.
1. To turn on the power, press the ON/RESET button
or begin pedalling. The entire display will briefly
appear; the console will then be ready for use.
2. Select one of the modes:
Scan mode—
When the power
is turned on, the
scan mode will be
selected automati-
cally. A mode indi-
cator will appear
below the scan
symbol to show
that the scan
mode is selected,
and a second
mode indicator will show which mode is currently
displayed. Note: If you have selected a different
mode, repeatedly press the MODE button to select
the scan mode again.
Speed, time, dis-
tance, or calorie
mode—To select
one of these
modes for continu-
ous display,
repeatedly press
the MODE button.
The mode indica-
tors will show
which mode is selected. Make sure there is not a
mode indicator below the scan symbol.
Note: The console can display speed and dis-
tance in either kilometres or miles. To change
the unit of measurement, press the ON/RESET
button for about five seconds. The letters km/h or
mph will appear in the display to show which unit of
measurement is selected. When the batteries are
replaced, it may be necessary to reselect the
desired unit of measurement.
Mode Indicators