Weslo WLEVEX12920 Home Gym User Manual


 
4
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable spanner , Phillips screw-
driver , and pliers .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a
part is not in the parts bag, check to see if it has been pre-attached.
3/8” Nylon
Locknut (33)–4
M8 Nylon
Locknut (10)–3
M8 Flat
Washer (51)–3
M8 x 15mm Button
Screw (34)–3
3/8” x 68mm Carriage Bolt (30)–4
Curved
Washer (42)–3
Ground
Screw (27)–1
M5 x 12mm
Screw (49)–4
M8 Split
Washer (55)–3
1. Set the Front Stabiliser (2) in front of the Frame (1),
with the Wheels (23) on the side shown. Whilst another
person lifts the front of the Frame slightly, attach the
Front Stabiliser with two 3/8” x 68mm Carriage Bolts
(30) and two 3/8” Nylon Locknuts (33). Make sure that
the Front Stabiliser is turned so the Wheels are not
touching the floor.
2
23
23
33
30
1
1
2. Whilst another person lifts the rear of the Frame (1)
slightly, attach the Rear Stabiliser (6) with two 3/8” x
68mm Carriage Bolts (30) and two 3/8” Nylon Locknuts
(33).
30
6
1
2
33
33