Filter
Top Products
6
7. Attach the Seat (12) to the Seat Post (5) with three M8
Flat Washers (51) and three M8 Nylon Locknuts (10).
Note: The Flat Washers and Nylon Locknuts may be
preattached to the underside of the Seat.
6. Whilst another person holds the Handlebar (15) near
the Upright (13), connect the console wire to the Upper
Wire (36). Insert the excess wire down into the Upright.
Attach the Handlebar to the Upright with three M8 x
15mm Button Screws (34), three M8 Split Washers
(55) and three Curved Washers (42). Be careful to
avoid pinching the wires.
15
36
34
55
13
42
55
34
34
42
6
Console Wire
7
51
12
51
10
10
5
5. Hold the Console (16) near the Handlebar (15).
Connect the ground wire to the Handlebar with the
Ground Screw (27). Insert the console wire into the
indicated hole in the Handlebar.
Move the Console (16) toward the Handlebar (15), at
the same time inserting the excess ground wire up into
the hole in the underside of the Console. Continue
until all of the excess ground wire is inside of the
Console. Attach the Console to the Handlebar with
four M5 x 12mm Screws (49). Be careful to avoid
pinching the wires.
16
5
Be careful to
avoid pinching
the wires.
Be careful
to avoid
pinching the
wires.
15
49
49
27
Ground
Wire
Hole
Console
Wire