Filter
Top Products
6
5. The Console (52) requires two ÒAAÓ batteries (not
included). Alkaline batteries are recommended.
To install batteries, first slide up the Battery Cover (60)
and carefully remove the battery clip from the Console
(52). Insert two batteries into the battery clip as shown.
Make sure that the negative ends of the batteries
(marked ÒÐÓ) are touching the springs in the
battery clip. Replace the battery clip and close the
Battery Cover.
5
60
52
Battery
Clip
Batteries
4. Make sure that there are two Pedal Leg Bushings
(39) in the left Pedal Leg (3). Apply a small amount
of grease to a Pedal Bolt (8). Insert the Pedal Bolt
into the left Pedal Leg and slide a Crank Spacer (41)
onto the Pedal Bolt. Tighten the Pedal Bolt into the
left Crank Arm (10), but do not overtighten it. You
should be able to turn the Crank Spacer with some
effort. Tighten a 1/2Ó Nylon Jam Nut (9) onto the
Pedal Bolt.
Repeat this step to attach the right Pedal Leg (not
shown).
39
8
10
3
9
41
4
6. Make sure that all parts of the ECLIPSE II are properly tightened. To protect the floor or carpet from
damage, place a mat under the ECLIPSE II.
3
40
45
46
6
2
3. Slide a Handlebar Spacer (46) onto the left axle on
the Upright (2). Make sure that the open side of the
Handlebar Spacer is facing the Upright. Next, make
sure that there are two Handlebar Bushings (40) in
the Left Handlebar (6). Slide the Left Handlebar onto
the left axle on the Upright. Tap a 5/8Ó Axle Cap (45)
onto the axle.
Repeat this step to attach the Right Handlebar (not
shown).