Filter
Top Products
10
MAINTENANCE
CONSOLE TROUBLE-SHOOTING
If the console does not function properly, the batteries
should be replaced. To replace the batteries, see
assembly step 5 on page 6. In addition, make sure
that the extension wire is plugged into the console.
(See assembly step 1 on page 5.)
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Side Shield (27) must first be removed.
Remove the 5/16Ó x 3/4Ó Tap Screw (18) from the left
Crank Arm (10). Slide the left Crank Arm off the Crank
Shaft (11). Remove the right Crank Arm (not shown) in
the same way.
Remove the three #8 x 3/4Ó Tec Screws (42) from
each side of the Side Shield (27).
Hold the Side Shield (27) near the back and pull it
apart slightly until the Side Shield can be lifted off the
ends of the Crank Shaft (11). Remove the Side Shield.
Do not pull the Side Shield apart at the top or the
seam may be broken.
Next, locate the
Reed Switch (48).
Turn the Pulley
(19) until the
Magnet (55) is
aligned with the
Reed Switch.
Loosen, but do
not remove, the
#10 x 1/2Ó Tec
Screw (51). Slide
the Reed Switch
slightly closer to or farther away from the Magnet.
Make sure that the Magnet will not hit the Reed
Switch. Retighten the Tec Screw. Turn the Pulley for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjusted,
reattach the side shield and the crank arms.
HOW TO ADJUST THE RESISTANCE STRAP
If the pedals do not have enough resistance, even
when the resistance knob is turned to the maximum
setting, the Resistance Strap (31) may need to be
adjusted. To adjust the Resistance Strap, the side
shield must first be removed. Refer to the instructions
at the left to remove the side shield.
Turn the resistance knob to the lowest setting. (See
HOW TO ADJUST THE RESISTANCE OF THE
PEDALS on page 7.) Grip the end of the Resistance
Strap (31) and
pull it away from
the rest of the
Strap. Next, pull
the end of the
Strap up to
remove any
slack. Then press
the end of the
Strap against the
rest of the Strap
as shown. Turn
the pulley for a
moment to make sure that there is not too much
resistance. When the Resistance Strap is properly
adjusted, reattach the side shield and the crank arms.
48
31
55
51
19
27
10
11
18
Back
Top
42