Filter
Top Products
5
2. Identify the Left Handlebar (6) and the left Extension
Tube (5) (there are stickers on the Handlebars and
Extension Tubes for identification). Make sure that
there is a Tree Fastener (63) in the Extension Tube.
If there is not, insert a Tree Fastener as shown.
Slide the Left Handlebar (6) onto the left Extension
Tube (5), being careful not to damage the Tree
Fastener (63). Align one of the three holes in the
Left Handlebar with the hole in the Extension Tube
and insert a Lock Pin (37) into the holes. Turn the
Lock Pin to the position shown in drawing 2a.
Repeat this step to attach the Right Handlebar to the
right Extension Tube (not shown).
ASSEMBLY
Assembly requires two persons. Place all parts of the WESLO
¨
ECLIPSE II in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included grease packet, a phillips screwdriver , two adjustable
wrenches , and a rubber mallet .
2
6
37
63
5
37
2a
6
1. Remove the #8 x 3/4Ó Tec Screw (42) from the Cable
Cover (53). While another person holds the Upright
(2) near the Base (1), carefully pull the Resistance
Cable (33) up through the Upright until there is no
slack between the Upright and the Base.
Next, insert the Extension Wire (49) into the Base (1)
until there is no slack between the Upright and the
Base.
Slide the Upright (2) onto the welded bolts on the
Base (1). Be careful to avoid pinching the
Extension Wire (49) and the Resistance Cable
(33). Tighten a 3/8Ó Nylon Locknut (54) onto each
welded bolt.
Insert the upper end of the Resistance Cable (33)
into the Upright (2) as shown. Insert the tab on the
Cable Cover (53) into the slot in the Upright. Attach
the Cable Cover to the Upright with the #8 x 3/4Ó Tec
Screw (42).
1
54
49
2
1
33
33
53
Slot
42