Filter
Top Products
9
49
8
8. Press the Book Rack (49) onto the Console Base (45) in
the location shown.
45
7. Place the Console Base (45) on the Right Handrail (5)
and the Left Handrail (not shown). Attach the Console
B
ase with four 3/4” Screws (77) (only two Screws are
shown).
Do not tighten the Screws yet.
Insert the Wire Harness (53) through the two indicated
plastic ties on the Console Base (45). Next, insert the
Wire Harness up through the opening beside the Wire
Cover (50). Make sure that the Wire Cover is securely at-
tached to the Console Base.
See drawing 7a. Look at the top of the Console Base
(45). Insert the Wire Harness (53) through the plastic tie
on top of the Console Base.
Tighten the two Crossbar Screws (86) (only one is
shown).
7
45
50
Ties
5
53
Tie
45
77
53
7a
9
9. Hold the Console (2) near the Console Base (45). Touch
the Right Handrail (5) to discharge any static. Find
the connector on the end of the Wire Harness (53).
Insert the connector into the red socket beneath the
Console. The connector should slide easily into the
socket and snap into place. If the connector does
not slide easily and snap into place, turn the connec
-
tor and then insert it. Make sure that the connector and
wires appear as shown in drawing 9a.
See drawing 7a. Insert the excess Wire Harness (53)
down into the opening in the Console Base (45).
Securely tighten the plastic tie on top of the Console
Base to prevent the Wire Harness from slipping.
Then, cut off the end of the plastic tie.
9a
2
53
Ties
53
5
45
86