Filter
Top Products
8
5. Identify the Right Handrail (5), which has a large hole in
t
he left side. Feed the Wire Harness (53) into the hole in
the bottom of the Right Handrail and out of the large hole
i
n the side. Note: It may be helpful to use needlenose pli-
ers to pull the Wire Harness out of the hole.
Press a Handrail Cap (87) onto the lower end of the
R
ight Handrail (5) as shown.
Set the Right Handrail (5) on the Right Upright (37), with
the Handrail Bracket (40) inserted into the lower end of
the Right Handrail.
Attach the Right Handrail (5) with an Upright Bolt (28) in
the upper end and a 3/4” Screw (77) in the lower end.
Do not tighten the Upright Bolt until step 6 is com-
pleted.
Attach the Left Handrail (4) as described above. Note:
There is not a wire harness on the left side.
53
Hole
5
28
4
32
77
87
77
37
40
87
5
Hole
28
65
53
6
86
86
4
5
89
6. See the inset drawings and identify the two Crossbar
Screws (86); be careful not to confuse the Crossbar
Screws with the 3/4” Screws (77). The Crossbar
Screws are slightly larger than the 3/4” Screws.
Hold the Crossbar (65) on the small brackets on the
Handrails (4, 5). Attach the Crossbar to the small brack-
ets with the two Crossbar Screws (86). Do not tighten
the Crossbar Screws yet.
Attach the end of the ground wire on the Wire Harness
(53) to the small hole in the left side of the Right Handrail
(5) with the Silver Ground Screw (89).
See step 5. Tighten the Upright Bolts (28).
86
Small Bracket
Small Bracket
77