Filter
Top Products
7
2. Identify the Left Upright (32) and the Right Upright (37),
which has a large round hole near the lower end.
S
ee drawing 2a. Make sure that there are two U-nuts
(93) in the lower end of each Upright (32, 37).
See drawing 2b. Have a second person hold the Base
(
55) so it is resting on the Wheels (34) as shown. M
ake
sure that the Base is oriented so that the Base Pads
(31) are in the location shown. Attach the Right and
Left Uprights (32, 37) to the Base with four Upright Bolts
(28) and four 5/16” Star Washers (68).
Do not tighten
the Bolts yet. Make sure that the large hole in the
Right Upright is on the side shown, and that the two
small holes in the Left Upright are on the side
shown.
93
68
68
37
32
Large
Hole
31
34
55
28
37
Hole
2
2a
2
b
31
34
36
90
21
3. With the help of a second person, place the Frame (21)
between the Uprights (32, 37). Feed the Wire Harness
(53) into the large round hole near the lower end of the
Right Upright (37), and then pull the Wire Harness out of
the upper end as shown.
See drawing 3a. Raise the Uprights (32, 37) to the vertical
position. Hold an Upright Spacer (58) against one side of
the Frame (21) as shown. Insert a Frame Bolt (36) into the
indicated hole in the Upright Spacer and the Frame. Next,
tighten a Spacer Screw (86) into the Upright Spacer and
the Frame. Remove the Frame Bolt. Repeat on the other
side of the Frame.
With the help of a second person, carefully lift the Frame
(21), and hold the Upright Spacers (58) between the Right
Upright (37) and the Left Upright (not shown). Align the in-
dicated hole in the Right Upright with the hole in the right
Upright Spacer. Insert a Frame Bolt (36), with a 3/8” Star
Washer (90), into the Right Upright and the Upright
Spacer, and loosely thread the Upright Bolt into the Frame.
Repeat this step on the left side of the treadmill.
58
86
3
4.
With the help of a second person, tip the treadmill so the
Base (not shown) is flat on the floor.
Insert the tab on one of the Handrail Brackets (40) into the
slot in the Right Upright (37). Attach the Handrail Bracket
with a 3/4” Screw (77); be careful not to confuse the
3/4” Screws with the slightly larger Crossbar Screws
(86, not shown). Attach the other Handrail Bracket to the
Left Upright (not shown) as described above.
40
37
77
Tab
Slot
4
Holes
3a
32, 37
Small
Holes
28
53
21
53
37
32
Hole