Filter
Top Products
9
8
8. Set the Console (2) in the Console Base (45). Make sure
that no wires are pinched.
Attach the Console (2) to the Console Base (45) with six
3
/4” Screws (77).
S
tart all six Screws before tighten-
ing them; do not overtighten the Screws.
9. Insert the excess Wire Harness (53) into the large hole in
the side of the right Handrail (4) Securely tighten the
plastic tie on the bottom of the Console Base to pre-
vent the Wire Harness from slipping. Then, cut off the
end of the plastic tie.
77
77
4
5
2
10. Attach the Console Base (45) to the Handrails (4) (only
one Handrail is shown) with four 3/4” Screws (77). Start
all four Screws before tightening them; do not over-
tighten the Screws.
77
4
45
53
Large Hole
Tie
53
4
38
77
11.
Attach the Storage Latch (38) to the Left Upright (32)
with two 3/4” Screws (77). Do not overtighten the
Screws.
32
9
10
11