Filter
Top Products
6. Place the Console Base (45) on the Handrails (4) (only
one Handrail is shown).
Insert the Wire Harness (53) through the indicated plastic
tie on the Console Base (45). Next, insert the Wire
Harness through the opening in the Console Base.
6
8
45
Tie
4
53
8
9
5
3
5
4
5. Attach the end of the ground wire on the Wire Harness
(53) to the small hole in the side of the right Handrail (4)
w
ith a Silver Ground Screw (89).
7
7. Hold the Console (2) near the Console Base (45). Touch
the right Handrail (4) to discharge any static. Find the
connector on the end of the Wire Harness (53). Insert
the connector into the red socket beneath the Console.
The connector should slide easily into the socket
and snap into place. If the connector does not slide
easily and snap into place, turn the connector and
then insert it. Make sure that the connector and wires
appear as shown in drawing 7a.
7a
2
53
53
4
45