Weslo WETL01540 Treadmill User Manual


 
4
ASSEMBLY
The help of a second person is recommended. Set the treadmill in a cleared area and remove all packing
materials. Do not dispose of the packing materials until assembly is completed. Assembly requires only the
included hex key and wrench .
38
13
13
37
37
38
Hole
Holes
Holes
1
1. Identify the Right Upright (36), which has a single hole in
the indicated location. Hold the Right Upright against the
Base (14) as shown, and orient the Right Upright so the
two indicated holes are on the side shown.
Attach the Right Upright (36) to the Base (14) with two
M8 x 50mm Bolts (38), two M8 Curved Washers (37),
and two M8 Nylon Nuts (13) as shown. Make sure that
the Curved Washers are turned so they conform to the
curve of the Base.
Do not tighten the Nylon Nuts yet.
Attach the Left Upright (35) to the Base (14) in the same
way. Make sure that the Left Upright is oriented so the
two indicated holes are on the side shown. Do not tight-
en the Nylon Nuts yet.
2. Raise the Left Upright (35) and the Right Upright (36) to
the position shown. Place the front of the Frame (29)
between the Left Upright and the Right Upright. Connect
the Reed Switch Wire (6) to the Short Reed Switch Wire
(A).
3. Attach the Hood (28) to the front of the Frame (29) with
two M5 x 10mm Bolts (10).
36
35
14
37
37
4a
4. See drawing 4a. Locate the small incline knob on each
side of the Frame (29). Slide the knobs into one of the
three sets of slots in the brackets on the Uprights (35).
Make sure that the knobs are fully inserted at the
same height.
Look under the Frame (29) near the Left Upright (35).
See drawing 4b. Locate the Clip (11) attached to the
underside of the Frame. Insert the Reed Switch (6) into
the Clip as shown. Next, locate the Magnet (12) on the
left Flywheel (9). Turn the Flywheel until the Magnet is
aligned with the Reed Switch.
Move the Reed Switch
so that there is a 3 mm (1/8 in.) gap between the
Reed Switch and the Magnet.
Then, tighten the M4 x
12mm Screw (3) in the Clip.
Bracket
Knob
29
12
9
3
1
1
6
1/8”
View from
beneath
35
4b
29
2
35
36
29
3
10
6
A
28
29