Filter
Top Products
12
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch may need to be adjusted. To adjust the
reed switch, you must first remove the left side shield
(see HOW TO REMOVE THE LEFT SIDE SHIELD on
page 11).
With the left side shield removed, locate the Reed
Switch (42). Turn the Crank (8) until the Magnet (61)
is aligned with the Reed Switch. Loosen, but do not
remove, the M4 x 16mm Screw (43). Slide the Reed
Switch slightly closer to or farther away from the
Magnet. Retighten the Screw. Turn the Crank for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the left side shield and the left pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If the resistance knob is set on its highest setting and
there is not enough resistance, the resistance strap
may need to be adjusted. To adjust the resistance
strap, you must first remove the left side shield (see
HOW TO REMOVE THE LEFT SIDE SHIELD on
page 11).
With the left side shield removed, turn the resistance
knob to the lowest setting (see HOW TO ADJUST
THE PEDALING RESISTANCE on page 9). Open the
Strap Clamp (57) and pull the end of the Resistance
Strap (41) slightly upward to increase resistance.
Close the Strap Clamp and turn the Flywheel (15) to
make sure that there is not too much resistance.
When the Resistance Strap is properly adjusted, re-
attach the left side shield and the left pedal.
42
61
43
8
Rear
View
57
15
41