Filter
Top Products
1. Make sure that the power cord is unplugged.
H
ave a second person hold the Base (52) in the
position shown.
Attach six Base Pads (63) (three are shown) to
the Base (52) with six Base Pad Screws (26).
Identify the Left Upright (53), which has two
small holes near the upper end. Hold the Left
Upright so the small holes face the direction
shown.
Attach the Left Upright to the Base (52)
with two Upright Bolts (2) and two Upright
Washers (14).
Do not tighten the Upright
Bolts yet.
Attach the Right Upright (54) to the Base (52)
in the same way.
1
53
Small
Holes
52
2
26
26
63
14
63
63
54
2. With the help of a second person, raise the
Uprights (53, 54) so the Base (52) is flat on the
floor as shown.
Attach a Wheel (70) to the outer side of the Base
(52) with a Wheel Bolt (35) and a Nut (16) as
shown.
Do not overtighten the Nuts; the
Wheels should turn freely.
Attach the other Wheel (70) to the outerside
of the Base (52) in the same way.
Position the front end of the treadmill Frame (51)
between the Uprights (53, 54) as shown. Next, lo-
cate the long wire inside the lower end of the
Right Upright (see the inset drawing). Securely
tie the end of the wire to the end of the Wire
Harness (39).
Then, pull the opposite end of the wire until the
Wire Harness (39) extends from the upper end of
the Right Upright (54).
2
52
16
70
35
54
51
53
39
39
54
Wire
7