Filter
Top Products
9
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 8).
Locate the reset/off circuit
breaker near the power cord.
Make sure that the circuit
breaker is in the on position.
Next, stand on the foot
rails of the treadmill.
Find the clip attached to
the key, and slide the
clip onto the waistband
of your clothes.
Insert the key fully into the console. After a moment,
the displays will light.
Test the clip by carefully tak-
ing a few steps backward until the key is pulled
from the console. If the key is not pulled from the
console, adjust the position of the clip.
Note: To prevent damage to the walking platform,
always wear clean shoes when using the treadmill.
Follow the steps below to operate the console.
Insert the key fully into the console.
A few seconds after the key is inserted,
the dis-
plays will light.
Press the Speed
▲
▲
button to start the walking
belt.
A moment after the button is pressed, the walking
belt will begin to move. Hold the handrails
and
begin walking.
2
1
CAUTION: Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
below) while operating the treadmill.
• Adjust the speed in small increments to
avoid sudden jumps in speed.
•
To reduce the possibility of electric shock,
keep
the console dry. Avoid spilling liquids
on the console and place only a sealed
water bottle in the water bottle holder.
Heart Rate
Sensor
CONSOLE DIAGRAM
Note: If there is a thin sheet of
plastic on the console, remove it.
Displays
Key
Clip
Reset