Filter
Top Products
4. Feed the Wire Harness (21) up into the rectangular
bracket on one of the Handrails (1) and out of the large
hole in the left side. Note: It may be helpful to use
needlenose pliers to pull the Wire Harness out of the
large hole.
Remove any plastic ties from the rectangular bracket on
the Handrail (1). Insert the bracket into the upper end of
the Right Upright (62). Tighten two 1” Bolts (8) 2 to 3
turns into the ends of the Handrail and into the Right
Upright. Do not tighten the Bolts yet.
Attach the other Handrail (1) as described above. Note:
There is not a wire harness on the left side.
Open part bag C. Attach the end of the ground wire to
the small hole in the side of the right Handrail (1) with a
Silver Screw (70).
3. With the help of a second person, tip the treadmill so the
Base Pads (40) (see drawing 1) are laying flat on the
f
loor. Raise the Uprights (62, 76) to the vertical position.
H
old the Crossbar (34) between the Uprights (62, 76).
Attach the Crossbar with two 2 1/2” Bolts (53) and two
5/16” Washers (57). Do not tighten the Bolts yet.
Large
Hole
Bracket
1
76
1
62
21
34
5
7
Ground
Wire
5
3
57
76
62
4
3
70
8
8
8
8
1
62
5
5. Place the Console Base (46) on the right Handrail (1)
and the left Handrail (not shown). Touch the Right
Upright (62) to discharge any static.
Hold the Console (10) near the Console Base (46). Insert
the Wire Harness (21) through the two indicated plastic
ties on the Console Base. Next, insert the Wire Harness
up through the indicated opening in the Console Base
and through the plastic tie on the bottom of the Console.
Locate the two connectors on the Wire Harness (21).
Plug the wider connector into the connector labeled A in
the drawing at the right. The connectors should slide
together easily and snap into place (see drawing 5a).
If they do not, turn the connector on the Wire Harness
and try again. Plug the other connector on the Wire
Harness into the connector labeled B (see drawing 5b).
IF THE CONNECTORS ARE NOT INSERTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Securely tighten the plastic tie on the Console (10) to
prevent the Wire Harness (21) from slipping.
Then,
cut off the end of the plastic tie.
21
Tie
46
10
B
6
Ties
53
5a
21
A
A
21
B
5b
21