Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials; do not dis-
pose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top
of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If
there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive
cleaner.
Assembly requires the included small allen wrench and your own phillips screwdriver , rubber
mallet , wire cutters , adjustable wrenches , and needlenose pliers
.
For help identifying the assembly hardware, refer to the PART IDENTIFICATION CHART in the center of
this manual. Note: The assembly hardware and other small parts are packaged in separate part bags. Do
not open the part bags until instructed to do so.
2. See drawing 2a. Make sure that there are two U-nuts
(97) in the lower end of each Upright (62, 76).
Identify the Right Upright (62), which has a large round
hole and a slot near the lower end. While a second per
-
son holds the Right Upright near the Wire Harness (21),
insert the end of the Wire Harness into the round hole
and out of the upper end of the Right Upright.
Open part bag B. Slide the slot in the Right Upright (62)
onto the Upright Lock
Bracket (47) (see drawing 2b). Slide
the Right Upright down until it reaches the Base (11).
Make
sure that the Wire Harness (21) is not pinched.
Handtighten
two 2 1/2” Bolts (53) and two Star Washers
(9) into the Base and Right Upright.
With the help of a second person, tip the treadmill onto
its other side. Attach the Left Upright (76) as described
above. (Note: There is not a wire harness on the left
side.) Attach the other Wheel (not shown) to the Base
(11) as described in step 1.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the tread-
mill onto its left side as shown. Partially fold the Frame
(75) so the treadmill is more stable. Do not fully fold the
treadmill until it is completely assembled.
Open part bag A. Attach four Base Pads (40) to the
Base (11) with two 1 1/4” Tek Screws (87) and two 3/4”
Tek Screws (25). Attach a Wheel (37) to the right side of
the Base with a Wheel Bolt (36) and a Wheel Nut (38).
!
!
5
75
37
36
11
25
40
40
40
87
87
25
38
62
47
21
76
11
53
9
Round Hole
Slot
62
Side View
97
62, 76
47
2
2a
2b
40
1