Filter
Top Products
6. While another person holds the Upright (13) in the
position shown,connect the console wire to the Reed
Switch Wire (43). Next, connect the Resistance Cable
(19) to the Lower Cable (45) in the following way:
• See drawing A. Pull up on the metal bracket on the
Lower Cable (45), and insertthe tip of the Resistance
Cable (19) into the wire clip inside the metal bracket
as shown.
• See drawing B. Firmly pull up the ResistanceCable
(19) and slide itintothe top of the metal bracket as
shown.
• See drawingC. Using pliers,squeeze the prongson
the upperend ofthe metal bracket together.
Push the excess Cable (19, 45) and theexcess console
wire down intothe Frame (1), and insert the Upright into
the Frame. Be careful to avoid pinching the Wires
and Cables. Attach the Uprightto the Frame with
three M8 x 15mm ButtonScrews(34) and three M8
SplitWashers(42).
7. Attach the Seat (12) to the Seat Post(5) with four M8
SplitWashers (42) and four M8 Nylon Locknuts(10).
Note:The SplitWashers and Nylon Locknutsmay be
preattachedto the underside of the Seat.
Be careful to
avoid pinching
the wires and
cables while
inserting the
Upright.
_I_r-- Console Wire
19/ I!i
,,,=_t; /43
1iI/
r
:34 _1
t,
A
_._ Metal
•"_-45
C
Metal1
Bracket
7
6