Weslo 795I Home Gym User Manual


 
6
1. Identify the Front Stabilizer (17), which has Wheels
(25) on the ends. Hold the Front Stabilizer against
the saddle on the front of the Frame (15). Make
sure that the Front Stabilizer is turned so the square
holes are facing away from the saddle. Attach the
Front Stabilizer with two M10 x 70mm Carriage
Bolts (30) and two M10 Nylon Locknuts (31).
Attach the Rear Stabilizer (not shown) to the rear of
the Frame (15) in the same manner.
ASSEMBLY
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed.
Assembly requires the included allen wrench , a phillips screwdriver and two
adjustable wrenches .
2
1
17
25
25
15
30
31
15
14
8
9
9
12
54
7
8
8
41
41
Console
Wire
7
Batteries
Battery Cover
14
41
8
3
5
3.
Attach the Handlebar (5) to the Handlebar Post (14)
with two M10 x 25mm Button Screws (8) and two
M10 Split Washers (41).
2. The Console (7) requires two AA batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Open the battery cover
on the underside of the Console as shown. Press
two batteries into the battery compartment. Make
sure that the negative ends of the batteries
(marked “–”) are touching the springs in the
battery compartment. Close the battery cover.
Insert the console wire through the Handlebar Post
(14). Connect the console wire to the Reed Switch
Wire (54). Attach the Console (7) to the Handlebar
Post with four M4 x 16mm Screws (9).
Carefully slide the Handlebar Post (14) onto the
Frame (15). Be careful to avoid pinching the
wires inside the Handlebar Post. Attach the
Handlebar Post with three M10 x 25mm Button
Screws (8) and three M10 Split W
ashers (41).
Attach the Knob Housing (12) to the Handlebar Post
with a M4 x 16mm Screw (9).