11
Inspect and tighten all parts of the exercise cycle
regularly
. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the batteries when storing the
exercise cycle.
HOW TO TIGHTEN THE CRANK
If the arms of the Crank (33) become loose, they
should be tightened in order to prevent excessive
wear. Loosen the Crank Nut (56) on the left arm of the
Crank. Place the end of a standard screwdriver in one
of the slots in the Crank Bearing Assembly (59).
Lightly tap the screwdriver with a hammer to turn the
Crank Bearing Assembly counterclockwise until the
arms are no longer loose. Do not overtighten the
Crank Bearing Assembly. When the Crank Bearing
Assembly is properly tightened, retighten the Crank
Nut.
BATTERY REPLACEMENT
If the console does not function properly
, the batteries
should be replaced. To replace the batteries, see
assembly step 2 on page 6. In addition, make sure
that the console wire is connected to the reed switch
wire.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (1) must be removed.
Using an adjustable wrench, turn the Left Pedal (28)
clockwise and remove it from the Crank (33). Remove
the two Side Shield Screws (4) and the three M4 x
32mm Screws (42) from the Left Side Shield. Next, lift
the Side Shield Cover (40) off the Side Shields. Grasp
both Side Shields at the top and gently pull them
apart. Make sure that the arm of the Crank is in the
position shown in the drawing above. Carefully slide
the Left Side Shield forward off the arm of the Crank
and remove it.
Next, locate the
Reed Switch (54).
Turn the Crank (33)
until the Magnet
(55) is aligned with
the Reed Switch.
Loosen but do not
remove the M4 x
16mm Screw (9).
Slide the Reed
Switch slightly clos-
er to or away from
the Magnet. Retighten the Screw
.
T
urn the Crank for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust
-
ed, reattach the left side shield and pedal.
MAINTENANCE AND TROUBLE-SHOOTING
56
59
33
28
33
42
42
42
40
1
4
54
33
9
55