Filter
Top Products
6
ASSEMBLY
1.
Orient the Left Base (4) so that the recessed
holes are facing the floor.
Identify the Left Upright (6), which is marked
with a “Left” sticker. Attach the Left Upright to
the Left Base (4) with two M10 x 57mm
Carriage Bolts (68) and two M10 Black
Locknuts (66). Do not tighten the Black
Locknuts yet. Make sure that the nut is in
the position shown.
Attach the Right Upright (7) to the Right
Base (5) in the same way.
1
6
7
5
Nut
68
Recessed
Holes
4
Nut
66
66
Before beginning assembly, make sure
that you understand the information in
the box above.
To make assembly easier, carefully read the
following information and instructions:
•
Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
•
The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
2. Attach the Crossbar (12) to the Left Upright (6)
with two M10 x 65mm Bolts (55), two M10
Black Washers (64), and two M10 Black
Locknuts (66). Do not tighten the Black
Locknuts yet.
Attach the Crossbar (12) to the Right
Upright (7) in the same way.
See steps 1–2. Tighten the M10 Black
Locknuts (66).
2
12
7
66
66
64
55
6