Filter
Top Products
15
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (31), slide the desired amount of
weight onto the Weight Adapter (36).
31
36
WARNING: Do not place more than
150 pounds on the Leg Lever (31).
ADJUSTING THE BACKREST
The Backrest (25) can be used in a decline position, a
level position, or either of two incline positions. To
adjust the Backrest to the decline position, remove the
Backrest Pin (40) and insert it through the top set of
holes in the Backrest Frames (23, 24) and the Bench
Frame (26).
To adjust the Backrest (25) to the level position, insert
the Backrest Pin (40) through the second set of holes in
the Backrest Frames (23, 24) and the Bench Frame (26).
To adjust the Backrest (25) to an incline position, insert
the Backrest Pin (40) through one of the two lower sets
of holes in the Backrest Frames (23, 24) and the Bench
Frame (26).
25
40
23
24
26
WARNING: When adjusting the
Backrest (25), make sure that the Backrest Pin
(40) is fully inserted through both Backrest
Frames (23, 24) and the holes in the Bench
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
CURL BAR OR THE BARBELL
To use the high or low pulley station, slide the desired
amount of weight onto the weight tubes of the Weight
Carriage (15) and secure the weights with Weight Clips
(43).
To use the Curl Bar (not shown) or Barbell (not shown),
slide the desired amount of weight onto each side of
the Weight Bar and secure both sides with a Weight
Clip (43).
43
15
Weight
Tube
Weight
Tube
WARNING: Do not place more than
150 pounds on the Weight Carriage (15). Always
place the same amount of weight on each side of
the Weight Carriage and on each side of the
Weight Bar (not shown). Always secure the
weights on the Weight Carriage and the Weight
Bar with the Weight Clips (43).