Filter
Top Products
10
14. Attach the Chin-up Bar (13) and two Joint Plates (6)
to the Front Uprights (7) using four M10 x 78mm
Bolts (70) and four M10 Nylon Locknuts (68). Do
not tighten the Nylon Locknuts yet.
17. Set the two Weight Bumpers (18) over the indicated
holes in the Weight Guide Base (4). Hold the
Weight Carriage (15) on top of the Weight
Bumpers.
Insert the two Weight Guides (9) into the Weight
Carriage (15), the Weight Bumpers (18), and the
Weight Guide Base (4). Attach the Weight Guides
using two M8 x 72mm Bolts (72), four M8 Flat
Washers (75), and two M8 Nylon Locknuts (69).
16. Press the two 51mm Round Inner Caps (89) into
the weight tubes on the Weight Carriage (15).
Press the two Carriage Bushings (16) into the
Weight Carriage (15). Make sure the Weight
Carriage is turned so the weight tubes are near
the top, as shown. Attach the lower Carriage
Bushing using an M10 x 66mm Bolt (74), two M10
Flat Washers (76), the 51mm Spacer (78), and an
M10 Nylon Locknut (68).
89
89
15
Weight Tube
16
16
74
76
78
76
68
6
70
70
68
68
6
7
13
7
14
15. Press a 60mm Square Inner Cap (57) into the Left
Frame (12). Attach the Left Frame to the left
Uprights (7, 8) using four M10 x 78mm Bolts (70)
and four M10 Nylon Locknuts (68). Do not tighten
the Nylon Locknuts yet.
Assemble the Right Frame (10) to the right Uprights
(7, 8) in the same manner.
Attach the Center Frame (11) to the Right and Left
Frames (10, 12) using four M10 x 78mm Bolts (70)
and four M10 Nylon Locknuts (68). Tighten all
Nylon Locknuts used in steps 10–15.
68
57
68
70
70
70
70
10
11
12
68
68
15
16
17
7
8
8
7
15
18
4
75
69
9
72