Filter
Top Products
9
12. Route the High Cable (23) up through the Top
Frame (6), around a 3 1/2” Pulley (16), and back
through the Top Frame. Attach the Pulley inside
the slot in the Top Frame with an M10 x 65mm
Bolt (19), two M10 Washers (15), two 15mm x
10.5mm Spacers (17), and an M10 Nylon Locknut
(20). Do not overtighten the Nylon Locknut;
the Pulley must be able to turn freely.
10
16
17
6
17
19
23
15
15
20
13. Attach the end of the High Cable (23) to the M10
x 20mm Bolt (21) in the Weight Carriage (7) with
an M10 Nylon Locknut (20) onto the Bolt.
11. Orient the Pulley Plates (27) as shown. Wrap the
High Cable (23) around a 3 1/2” Pulley (16).
Attach the Pulley and a Cable Trap (26) to the top
set of holes in the Pulley Plates with an M10 x
45mm Bolt (18) and an M10 Nylon Locknut (20).
Make sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley. Do not over-
tighten the Nylon Locknut; the Pulley must be
able to turn freely.
19
6
15
23
15
17
17
20
7
21
20
23
16
12
13
23
27
27
18
26
16
20
11
10. Route the High Cable (23) around a 3 1/2” Pulley
(16) and through the indicated slot in the Top
Frame (6). Attach the Pulley inside the slot using
an M10 x 65mm Bolt (19), two M10 Washers
(15), two 15mm x 10.5mm Spacers (17), and an
M10 Nylon Locknut (20). Do not overtighten the
Nylon Locknut; the Pulley must be able to
turn freely.