Filter
Top Products
6
1. Before beginning, make sure that you under-
stand the information in the box above. Note:
Some parts described in the assembly steps
may be pre-assembled.
Press a 60mm Square Inner Cap (11) into the
end of the Rear Base (8).
Attach the Rear Base (8) and the Foot Plate (10)
to the Base (3) with two M10 x 80mm Bolts (22)
and two M10 Nylon Locknuts (20). Do not tighten
the Nylon Locknuts yet.
2. Press two 60mm Square Inner Caps (11) into the
ends of each Stabilizer (5).
Attach the Stabilizer (5) to one end of the Base
(3) with two M10 x 80mm Bolts (22), a Support
Plate (29), and two M10 Nylon Locknuts (20). Do
not tighten the Nylon Locknuts yet.
Assemble the other Stabilizer (5) in the same
manner. Note: There is a warning decal on one
of the Stabilizers; make sure it is in the posi-
tion shown.
1
22
8
20
20
11
3
10
2
22
11
20
Decal
11
22
29
3
5
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight rack can be assembled successfully by
anyone. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY