Filter
Top Products
3. Attach an Upright (1) to a Stabilizer (5) with four
M10 x 80mm Bolts (22), two Joint Plates (9), and
four M10 Nylon Locknuts (20). Make sure that
the Uprights are oriented with the adjustment
holes on the side indicated. Do not tighten the
Nylon Locknuts yet.
Repeat this step with the other Upright (1).
3
20
1
Adjustment Holes
on this side
22
22
5
9
9
20
7
4. Press 75mm x 65mm Bushings (32) into the top
and bottom of a Weight Rest (30) and a Safety
Spotter (31). Screw Adjustment Knobs (33) into
the Weight Rest and the Safety Spotter.
Pull the Adjustment Knob (33) on the Safety
Spotter (31) out as far as it will go. Slide the
Safety Spotter over an Upright (1). Snap the Knob
into one of the lower adjustment holes in the
Upright. Turn the Knob clockwise until it is tight.
Attach a Weight Rest (30) to the Upright in the
same manner. Be sure the Adjustment Knobs
are on the same side of the Uprights as the
adjustment holes.
Repeat this step with the other Upright (1).
Note: Make sure that both Weight Rests (30)
and both Safety Spotters (31) are at the same
height.
30
32
32
32
1
31
33
33
4
5. Press a 60mm Square Inner Cap (11) into each
end of the Crossbar (4).
Attach the Crossbar (4) to each Upright (1) with
four M10 x 80mm Bolts (22), two Joint Plates (9),
and four M10 Nylon Locknuts (20). Do not tight-
en the Nylon Locknuts yet. Be sure the name
decal is on the side shown.
1
22
9
9
20
20
4
Name Decal
11
5
Adjustment Holes
on this side