Filter
Top Products
9
13. Press a 50mm Square Inner Cap (10) into each
end of the Pulley Bar (59). Slide the bracket on
the Pulley Bar into the top of the Rear Upright (2).
Attach the Pulley Bar to the Rear Upright using
two M10 x 65mm Bolts (56), four M10 Small
Washers (6), and two M10 Nylon Locknuts (11).
Attach the Pulley Bar (59) to the Top Crossbar (9)
using a Support Plate (57), two M10 x 80mm
Bolts (41), and two M10 Nylon Locknuts (11).
Tighten all M10 Nylon Locknuts (11) used in
steps 1–13.
15. Route the High Cable (13) around another Pulley
(5) and through the indicated slot in the Pulley
Bar (59) as shown. Attach the Pulley inside the
slot using an M10 x 65mm Bolt (56), two M10
Large Washers (58), two Pulley Spacers (15),
and an M10 Nylon Locknut (11). Do not over-
tighten the Nylon Locknut; the Pulley must be
able to turn freely.
16. Route the High Cable (13) up through the Pulley
Bar (59), around another Pulley (5), and back
down through the Pulley Bar, as shown. Attach
the Pulley inside the slot in the Pulley Bar using
an M10 x 65mm Bolt (56), two M10 Large
Washers (58), two Pulley Spacers (15), and an
M10 Nylon Locknut (11). Do not overtighten the
Nylon Locknut; the Pulley must be able to
turn freely.
56
58
5
59
15
15
13
Ball
11
58
14
56
58
59
58
11
13
5
15
15
15
57
41
10
10
11
11
59
6
9
56
Bracket
2
14. Identify the High Cable (13), which is the shorter
of the two Cables. Route the High Cable up
through the indicated slot in the Pulley Bar (59).
Make sure the ball is in the indicated location.
Route the High Cable (13) around a Pulley (5) as
shown. Attach the Pulley inside the slot in the
Pulley Bar (59) using an M10 x 65mm Bolt (56),
two M10 Large Washers (58), two Pulley Spacers
(15), and an M10 Nylon Locknut (11). Do not
overtighten the Nylon Locknut; the Pulley
must be able to turn freely.
13
16
5
15
56
58
15
11
58
13
59