Filter
Top Products
11
21. Attach the indicated end of the Low Cable (8) to
the bracket on the Rear Base (3) using an M10 x
20mm Bolt (26) and an M10 Nylon Locknut (11).
21
26
11
3
8
Bracket
22. Press two 50mm x 70mm Inner Caps (60) into
the ends of the Stabilizer (87).
Attach the Stabilizer (87) to the Bench Frame (63)
with two M10 x 60mm Carriage Bolts (64) and
two M10 Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Note: The indents around the holes in the
Stabilizer (87) should be on the bottom, and
the decal should be in the indicated location.
23. Press two 50mm Square Inner Caps (10) into the
ends of the Front Leg Base (89).
Attach the Front Leg (73) to the Front Leg Base
(89) using the two Front Leg Plates (90), four
M10 x 70mm Bolts (85), and four M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
22
23
64
Indents
Decal
60
60
63
87
11
73
89
10
10
11
85
85
90