Filter
Top Products
12
26. Lubricate an M10 x 70mm Bolt (85). Attach the
Leg Lever (72) to the Front Leg (73) with the Bolt
and an M10 Nylon Locknut (11). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot freely.
26
24. Attach the Front Leg (73) to the Bench Frame
(63) using two Small Joint Plates (91), four M10 x
70mm Bolts (85), and four M10 Nylon Locknuts
(11).
Tighten the M10 Nylon Locknuts (11) used in
steps 22–24.
Insert the Bench Knob (80) into the Bench Frame
(63) and tighten it fully.
27. Press four 25mm Square Inner Caps (79) into the
ends of the Backrest Frames (78).
Attach the Backrest Bracket (53) to the Backrest
Frames (78) with four M10 x 45mm Bolts (40),
four M10 Small Washers (6), and four M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
24
63
80
73
11
91
91
85
27
Lubricate
72
11
85
73
79
79
78
11
11
40
40
40
53
6
6
6
6
71
71
71
82
67
67
75
72
70
74
54
25
84
25. Press three 45mm Square Inner Caps (71) into
the Leg Lever (72). Press a 25mm Round Inner
Cap (84) into the indicated end of the Weight
Tube (75).
Attach the Weight Tube (75) to the Leg Lever (72)
with an M8 x 55mm Bolt (70), two M8 Flat
Washers (67), a 10mm Spacer (74), and an M8
Nylon Locknut (54).
Press an Angled Outer Cap (82) onto the back
end of the Weight Tube (75).