Filter
Top Products
8
6. Apply a portion of the included grease to an
M10 x 165mm Bolt (50). Attach the Backrest
F
rames (16) to the Frame (1) with the Bolt, two
M10 Washers (55), and an M10 Nylon Locknut
(
42). Set the end of the Backrest Post (15) in
one of the slots in the Frame. Do not over-
tighten the Nylon Locknut; the Backrest
Frames must pivot easily.
See step 5. Tighten the M10 Nylon Locknut
(42) and the four M6 x 40mm Screws (51). Do
not overtighten the Nylon Locknut; the
Backrest Post (15) must pivot easily.
7. Attach the Weight Tube (24) to the Leg Lever
(5) with an M8 x 70mm Bolt (46), a Weight
Tube Spacer (41), two M8 Washers (49), and
an M8 Nylon Locknut (36). Then, press a 25mm
Round Outer Cap (29) onto the Weight Tube.
Apply grease to the barrel of an M10 x 77mm
Bolt Set (47). Attach the Leg Lever (5) to the
Front Leg (4) with the Bolt Set.
Make sure that
the barrel of the Bolt Set is inserted through
both sides of the bracket on the Front Leg.
6
7
16
1
42
15
Slot
55
50
55
4
47
47
Grease
Bracket
5
36
49
49
29
41
46
24
Grease
8. Insert the Long Pad Tube (56) into the bracket
on the Front Leg (4). Slide two Foam Pads (22)
onto the Pad Tube, and then press two Pad
Caps (23) into the Foam Pads.
Repeat this step with the two Short Pad
Tubes (21) and the Leg Lever (5).
8
23
23
4
5
22
22
56
21
21
Bracket