Filter
Top Products
19
38. Wrap the Low Cable (70) under a Pulley (43).
Attach the Pulley, an M10 Washer (108), and two
H
alf Guards (46) to the Right Base (1) with an
M10 x 45mm Bolt (95) and an M10 Nylon Locknut
(
84). M
ake sure the Half Guards are oriented
as shown.
39. Route the Low Cable (70) over a Pulley (43) and
through the Center Upright (9). Attach the Pulley
inside the Center Upright with an M10 x 65mm
Bolt (87), two M10 Washers (108), two 1/2”
Bushings (68), and an M10 Nylon Locknut (84).
40. Wrap the Low Cable (70) under a Pulley (43).
Attach the Pulley, a Cable Trap (48), and a Guard
(45) to the Small Pulley Plate (50) with an M10 x
50mm Bolt (105) and an M10 Nylon Locknut (84).
Make sure that the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
3
8
1
84
4
6
4
3
1
08
7
0
95
46
40
41
84
39
105
50
43
48
45
70
84
84
43
4
95
70
41. W
rap the Low Cable (70) over a Pulley (43).
Attach the Pulley to the Left
T
op Frame (4) with
an M10 x 45mm Bolt (95) and an M10 Nylon
Locknut (84).
68
68
87
9
43
70
108
108