Filter
Top Products
18
35. Attach a Pulley (43) inside the Curl Post Upright
(10), above the Low Cable (70), with an M10 x
6
5mm Bolt (87), two M10 Washers (108), two 1/2”
Bushings (68), and an M10 Nylon Locknut (84).
36. Route the Low Cable (70) through the Right Seat
Upright (11) and the Right Upright (7) and under a
Pulley (43). Attach the Pulley, an M10 Washer
(108), and two Half Guards (46) to the Right Base
(1) with an M10 x 45mm Bolt (95) and an M10
Nylon Locknut (84). Make sure the Half Guards
are oriented as shown.
35
36
37
108
70
1
0
87
68
108
108
46
11
1
46
43
70
7
95
84
43
8
4
68
84
46
46
49
105
48
43
70
37. Wrap the Low Cable (70) over a Pulley (43).
Attach the Pulley, a Cable Trap (48), and two Half
Guards (46) at the second hole from the bottom
of the two Pulley Plates (49) with an M10 x 50mm
Bolt (105) and an M10 Nylon Locknut (84).
Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley. Make
sure the Half Guards are oriented as shown.