Filter
Top Products
11
12
9
ARM ASSEMBLY
69
23
23
67
69
40
2
23
67
40
2
54
42
12
13
52ÑLubricate
Tube
Welded
Spacers
High
Pulley
FRAME ASSEMBLY
11. Attach the upper ends of one set of Weight
Guides (23) to the Top Frame (2) with a 5/16Ó
x 6Ó Bolt (67), two 1/2Ó x 3/4Ó Spacers (69),
and a 5/16Ó Nylon Locknut (40). Do not over
tighten the Nylon Locknut.
12. Attach the upper ends of the other set of
Weight Guides (23) to the Top Frame (2) with
a 5/16Ó x 6Ó Bolt (67), two 1/2Ó x 3/4Ó Spacers
(69), and a 5/16Ó Nylon Locknut (40). Do not
over tighten the Nylon Locknut.
Before continuing, firmly tighten all nylon
locknuts used in steps 1 through 12.
13. Locate and open the parts bag labeled
ÒARM ASSEMBLY.Ó
Press a 1Ó x 7/8Ó Plastic Bushing (54) onto
each welded spacer on the Press Frame (12).
Slide the Press Frame onto the Press Base
(13) so that the Plastic Bushings are aligned
with the indicated tube. Note: This will be a
tight fit. Make sure that the high pulley is
on the side shown.
Lubricate the 3/8Ó x 8Ó Bolt (52). Attach the
Press Frame (12) to the Press Base (13) with
the Bolt and a 3/8Ó Nylon Locknut (42).
13