Filter
Top Products
17
39. Locate the remaining preassembled pair of
Pulley Plates (31) and 3 1/2Ó Pulleys (82).
Route the High Cable (84) around the indicat-
ed 3 1/2Ó Pulley (82). The end of the Pulley
Plates (31) with two holes should be down-
ward. Be sure that the Cable is between
the Cable Trap (80) and the Pulley, and that
the Cable Trap is positioned to hold the
Cable in place. Refer to the inset drawing.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó
Nylon Locknut (not shown).
40. Wrap the High Cable (84) around a 3 1/2Ó
Pulley (82). Attach the Pulley to the Top
Frame (2) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó
Nylon Locknut (42). The Cable must be
routed in the direction shown.
41. Attach the High Cable (84) to a Small ÒUÓ
Bracket (32) with a 1/4Ó Washer (37) and a
1/4Ó Nylon Locknut (44). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the Cable enough to be
secure; as shown in the inset drawing.
Attach the Small ÒUÓ Bracket (32) to the indi-
cated Weight Tube (25) with a 5/16Ó x 1 3/4Ó
Bolt (68) and a 5/16Ó Nylon Locknut (40).
42. Lay the Ab Cable (85) over a 3 1/2Ó Pulley
(82). Attach the Pulley and both Pulley Covers
(74) to the Ab Upright (1) with the 3/8Ó x 4Ó
Bolt (73), two 3/8Ó Washers (38), and a 3/8Ó
Nylon Locknut (42). Make sure that the
Cable is between the Pulley and the post.
Do not over tighten the Nylon Locknut; the
Pulley should turn easily.
The Pulley Covers (74) must be turned so
that the small tabs face away from the
training system.
42
39
40
41
CABLE ASSEMBLY
84
84
80
50
31
42
Post
1
85
74; Small
tabs must
be in this
location
38
38
73
82
End with two
holes should
be down
50
82
2
42
32
68
84
40
37
44
25
84
44
32
37
82
84