Filter
Top Products
1.
Locate and open the parts bags labeled
ÒFRAME ASSEMBLY BAG ONEÓ and
ÒFRAME ASSEMBLY BAG TWO.Ó
Press two 2Ó Square Outer Caps (58) onto the
Weight Base (14) in the indicated locations.
Press a 2Ó Square Inner Cap (56) into the end
of the Weight Base.
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (49)
up through the Weight Base (14). Insert four
5/16Ó x 2 1/2Ó Carriage Bolts (49) up through
the Press Base (13).
Press a 2Ó Square Inner Cap (56) into the end
of the Press Base (13). Attach the Press Base
to the Weight Base (14) with two 5/16Ó x 2
3/4Ó Bolts (55), two 5/16Ó Washers (20), and
two 5/16Ó Nylon Locknuts (40).
2. Slide the Ab Upright (1) onto the indicated
5/16Ó x 2 1/2Ó Carriage Bolts (49) in the
Weight Base (14). Hand tighten two 5/16Ó
Nylon Locknuts (40) onto the Carriage Bolts.
Do not tighten the Nylon Locknuts yet.
Slide the Press Upright (4) onto the indicated
5/16Ó x 2 1/2Ó Carriage Bolts (49) in the Press
Base (13). Hand tighten two 5/16Ó Nylon
Locknuts (40) onto the Carriage Bolts. Do not
tighten the Nylon Locknuts yet.
3. Press two 2Ó Square Inner Caps (56) into the
ends of the Top Frame (2). Press two 2Ó
Square Inner Caps (56) into the indicated
sides of the Butterfly Frame (3). Press two 1Ó
Inner Caps (65) into the top of the Butterfly
Frame.
Attach the Butterfly Frame (3) to the Top
Frame (2) with a 5/16Ó x 3Ó Bolt (91), 5/16Ó
Flat Washers (20), and a 5/16Ó Nylon Jam Nut
(90). Be sure that the Bolt is on the side
shown.
Finish attaching the Butterfly Frame (3) to the
Top Frame (2) with a 5/16Ó x 2 3/4Ó Bolt (55),
5/16Ó Flat Washers (20), and a 5/16Ó Nylon
Locknut (40).
2
3
FRAME ASSEMBLY
6
1
4
40
40
49
49
13
2
3
14
55
40
20
56
56
56
56
91
65
20
90
Before you begin this step, make sure
that you have read all of the information
on page 5. This brief introduction will
save you much more time than it takes
to read it!
1
56
58
58
55
56
20
49
40
49
13
14