Filter
Top Products
6
5. Set two Weight Bumpers (19) onto the bracket
on the Stabilizer (5). Insert both Weight Guides
through the Weight Bumpers and the bracket
on the Stabilizer. Be sure that the drilled
holes in the Weight Guides are at the top,
as shown. Press a 1” Round Cover Cap (70)
onto the bottom of each Weight Guide (62).
Slide eight Weights (25) on the Weight Guides
(62). Be sure that all of the Weights are
turned so the pin grooves are on the same
side.
6. Press the Weight Tube Bumper (64) into the
end of the Weight Tube (63). Insert the Weight
Tube into the stack of Weights (25). Be sure
that the pins on the Weight Tube are resting in
the pin grooves in the upper Weight.
Lubricate the insides of the holes in the Top
Weight (76). Slide the Top Weight onto the
Weight Guides (62) and set it on the stack of
Weights (25).
7. Press a 2” Square Inner Cap (27) into each
end of the Top Frame (55). Press a 1 3/4”
Square Inner Cap (44) into each end of the
crossbar on the Top Frame. Press two 1”
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16”
x 2 3/4” Bolts (11), four 5/16” Flat Washers
(8), and four 5/16” Nylon Locknuts (3).
7
6
5
FRAME ASSEMBLY
11
8
3
27
42
25
Pin Grooves must
be on this side
19
5
70
70
64
63
Lubricate
Pins
76
62
62
25
Drilled holes must
be at the top
Crossbar
49
44
44
27
27
11
8
3
55
56