Filter
Top Products
13
26. Slide the Pad Tube (50) into the Leg Lever (56).
Slide two Large Foam Pads (52) onto the Pad
T
ube.
Attach the other Pad T
ube (50) to the Leg
Lever (56) and the Leg (5) in the same manner.
28. Wrap a High Cable (101) over a 90mm Pulley
(40). Attach the Pulley to a Pulley Housing (39)
with an M10 x 44mm Button Bolt (93) and an M10
Nylon Locknut (103).
Repeat this step with the other High Cable
(101) and Pulley Housing (39).
29. Make sure that all parts have been properly tight-
ened.
The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
following page.
Before using the resistance system, turn on
the console and change the resistance setting
as described in CONSOLE OPERATION on
page 18. Refer to TROUBLESHOOTING on
page 21 and adjust the Crossbar Cable ten-
sion as described.
27. Attach a 90mm Pulley (40) inside of the Leg (5)
with an M10 x 85mm Button Bolt (92), two M10
Washers (106), two 22mm Spacers (61), and an
M10 Nylon Locknut (103).
26
27
28
103
39
40
93
101
52
52
56
5
50
50
40
5
61
61 106
106
127
103