Filter
Top Products
25
TROUBLESHOOTING
Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi-
ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the
weight pins into the centers of the weight stacks. Slack can be removed from the cables in several ways:
See drawing 1. To tighten the Squat Cable (73) or the Swivel
High Cable (not shown), first loosen the 1/2” Nut (118) on the
end of the Cable, away from the 1/2” Washer (1). Screw the
end of the Cable farther into the Weight Tube (43). Then,
retighten the Nut against the Washer.
See drawing 3. To tighten the other five cables, first remove
the upper or lower 3/8” Nylon Locknut (87), 3/8” x 2” Bolt
(100), 3 1/2” Pulley (78), and Cable Trap (68) from the Pulley
Plates (63) or Small Pulley Plates (not shown). Reattach the
Pulley and the Cable Trap between a set of holes closer to
the center of the Pulley Plates with the Bolt and Locknut.
See drawing 2. To further tighten the Squat Cable (73), first
remove the 3/8” Nylon Locknut (87), the 3/8" x 2" Bolt (100),
Cable Trap (68), and 3 1/2” Pulley (78) from the indicated
bracket on the Long Base (120). Reattach the Pulley and
Cable Trap between a lower set of holes with the Bolt and
Nylon Locknut.
See drawing 4. To remove additional slack, first remove the
3/8” Nylon Locknut (87), 3/8” x 2” Bolt (100), 3 1/2” Pulley
(78), and Cable Trap (68) from the “U”-bracket (64). Reattach
the Pulley and the Cable Trap between the higher set of
holes in the “U”-bracket with the Bolt and Nylon Locknut.
Do not overtighten the cables. If the cables are overtight-
ened, the top weights will be lifted off the weight stacks.
If a cable slips off the pulleys repeatedly, it may have
become twisted. Remove the cable and re-install it. If the
cables need to be replaced, see ORDERING REPLACE-
MENT PARTS on the back cover of this manual.
100
68
3
1
2
4
73
1
118
43
78
68
73
87
120
100
87
87
63
64
78
100
68
78